Casio celviano ap-700 - Page 57

EN-56
Getting Ready
1. Unfasten the band
1
that bundles the pedal
cable to the back of crosspiece
D
and pull
the pedal cord out from the crosspiece.
2. Attach side panels
A
and
B
to crosspiece
D
. Secure the side panels using four screws
E
.
• When installing parts
2
, slide the brackets
3
into
the slots in either end of crosspiece
D
. If the brackets
3
are not inserted into the ends of the crosspiece
D
as far as they will go, the screws
E
will not be able to
enter into the screw holes of the brackets
3
, which
can strip the threads of the screws.
• Cover the screw heads with the caps
I
.
3. Slide back panel
C
into the grooves
4
of
the side panels.
• When installing back panel
C
, make sure that the
widely spaced screw holes along the bottom of the
panel are on the left (when viewed from the front of
the stand), and the narrowly spaced holes are on the
right.
4. Use the two screws
H
to secure the top left
and right edges of the back panel
C
to the
brackets
5
of side panels
A
and
B
.
• At location
6
, slip the clip
G
onto to the screw
H
before installing the screw.
1
Pedal cable
A
D
B
I
I
3
2
E
E
C
4
4
H
H
5
6
5
G
H
B
A
5
AP700-ES-1B.indd 58 2015/04/06 12:23:05