— 22 —
If you keep having problems when you are trying to perform operations, try the following before assuming that
there is something wrong with the calculator.
• Get the Calculator Back to its Original Mode Settings
1. In the Main Menu, select the RUN icon and press
EXE
.
2. Press
SHIFT
SET UP
to display the set up screen.
3. Highlight "Angle" and press
F2
(Rad).
4. Highlight "Display" and press
F3
(Norm) to select the exponential display range (Norm 1 or Norm 2) that
you want to use.
5. Now enter the correct mode and perform your calculation again, monitoring the results on the display.
• In Case of Hang Up
• Should the unit hang up and stop responding to input from the keyboard, press the P button on the back
of the calculator to reset the memory. Note, however, that this clears all the data in calculator memory.
• Low Battery Message
The low battery message apppears whenever you press
AC/ON
to turn power on or
MENU
to display the Main
Menu while the main battery power is below a certain level.
If you continue using the calculator without replacing batteries, power will automatically turn off to protect
memory contents. Once this happens, you will not be able to turn power back on, and there is the danger that
memory contents will be corrupted or lost entirely.
• You will not be able to perform data communications operations once the low battery message appears.
9. OPERATION PROBLEMS
AC/ON
or
MENU
To Next Page
Loading...
Need help?
General
