20070201
3-1-5
Inputting and Editing a List
k Naming a List
You can assign List 1 through List 26 “sub names” of up to eight bytes each.
u To name a list
1. On the Setup screen, highlight “Sub Name” and then press 1 (On)J .
2. Use the cursor keys to move the highlighting to the SUB cell of the list you want to
name.
3. Type in the name and then press w .
• To type in a name using alpha characters, press !a to enter the ALPHA-LOCK
mode.
Example: YEAR
- (Y)c (E)v (A)g (R)
• The following operation displays a sub name in the RUN
•
MAT mode.
! b (List) n ! + ( [ )a ! - ( ] )w
(
n = list number from 1 to 26)
# Though you can input up to 8 bytes for the
sub name, only the characters that can fi t
within the List Editor cell will be displayed.
# The List Editor SUB cell is not displayed when
“Off” is selected for “Sub Name” on the Setup
screen.
To Next Page
Loading...
Need help?
General
