20070201
u To generate a table using a list
1. While the Table relation list is on the screen, display the Setup screen.
2. Highlight Variable and then press 2 (LIST) to display the pop-up window.
3. Select the list whose values you want to assign for the
x -variable.
• To select List 6, for example, press g w . This causes the setting of the Variable item
of the Setup screen to change to List 6.
4. After specifying the list you want to use, press J to return to the previous screen.
u Generating a Table
Example To generate a table of values for the functions stored in memory areas
Y1 and Y3 of the Table relation list
Use f and c to move the highlighting to the function you want to select for table
generation and press 1 (SEL) to select it.
The “=” sign of selected functions is highlighted on the screen. To deselect a function, move
the cursor to it and press 1 (SEL) again.
Press 6 (TABL) to generate a number table using the functions you selected. The value of
variable x changes according to the range or the contents of the list you specifi ed.
The example screen shown here shows the results
based on the contents of List 6 (– 3, –2, –1, 0, 1, 2, 3).
Each cell can contain up to six digits, including negative sign.
5-7-2
Using Tables
To Next Page
Loading...
Need help?
General
