20110901
2-2-1
Connecting the ClassPad to Another Device
2-2 Connecting the ClassPad to Another Device
This section provides detailed explanations about how to connect the ClassPad to another
ClassPad unit, to a computer, to a CASIO Data Analyzer, and to a CASIO Projector.
Connecting to Another ClassPad Unit
Use the procedure below to connect two ClassPad units.
k
Required Hardware
ClassPad: 2 units
Special SB-62 Cable: 1
u
ClassPad Operation
(1) Turn both units off.
(2) Connect the data communication cable as shown in the illustration below.
• Insert both of the plugs securely, as far as they will go.
Cable
• For information about what you should do to transfer data, see “2-4 Transferring
Data to Another ClassPad Unit”.
To Next Page
Loading...
Need help?
General
