– 22 –
Loading and Removing an Ink Ribbon Cassette
An ink ribbon cassette is required when printing disc labels.
You should use only the special ink ribbon cassettes that are specified for this printer.
To load the ink ribbon cassette
1. Open the cassette cover.
2. Remove the stopper from the ink ribbon cassette.
3. If there is slack in the ink ribbon, use your fingers as shown in the illustration to
rotate the spindle of the cassette to remove the slack.
• You may need to rotate the spindle several times if there is a lot of slack.
Important!
• Never pull on the ink ribbon with excessive force or try to push the ink ribbon
into the cassette.
• Loading the ink ribbon cassette while the ink ribbon is slack creates the risk of
malfunction.
Stopper
Rotate in the direction
of the arrow.
To Next Page
Loading...
Need help?
General
