Casio DT-940 - Page 16

― 14 ―
3.3.3 LASER-MODULE DISASSEMBLY/ASSEMBLY (DT-940)
Procedures
(1) Peel off the Tape, unlock the connector lock, and remove the FPC.
(2)
Remove three B screws (+, silver).
(3) Remove LASER-HOLDER.
(4) Remove four B screws (+, silver).
(5)
Remove LASER-BASE.
(6) Unlock the connector lock, and remove the FPC.
(7) Remove two D screws (+, silver).
(8) Remove LASER-MODULE.
(1)
(2) B Screws
(3)
(4) B Screws
(5)
(7) D Screws
(8)
LASER-MODULE
(6) FPC
When the FPC is replaced with a new one,
form its shape as shown below.
9 ± 1 mm