Casio DT-940 - Page 21

― 19 ―
(3) Disconnect FFC-CABLE and cords from LCD.
Disconnect FFC-CABLE and cords from LCD.
< Note >
(1) Fit the cables from TRIGGER-KEY/R into a cut of the case.
(2) Pass the LCD cables through the space between bosses. Do not run the cables over them.
(3) Do not run the LCD cables over the ribs of the case.
(3)
(2)
Down-facing reader port Forward-facing reader port
OK NG
The cable should run
around the left half
perimeter of the boss.
The cable runs
around the right pe-
rimeter of the boss.
The cable should run
around the right perimeter
the rib.
The cable should run around the left half
perimeter of the boss.