Casio DT-X100 Series - Attaching the Hand Strap; Hand Strap Attachment Steps

E-16
Attaching the Hand Strap
The hand strap can be used to prevent the Handheld Terminal from dropping when
carrying it around. Since there are two strap holes where the hand strap can be attached,
use the hole that affords the ease of use. Attach the hand strap according to the
procedure described below.
To attach the hand strap
1. Pass the thin cord of the hand strap through the hand strap hole on the back of the
Handheld Terminal.
2. Pass the other end of the strap (the part you put around your hand) through the loop
formed by the thin cord.
Important!
Do not swing the Handheld Terminal around holding the hand strap.