Casio DT-X100 Series - Laser Scanner Safety and Scanning Tips; Understanding Laser Warning Labels; Optimal Barcode Positioning for Scanning

E-21
Warning Label
This label is a warning and caution label for Class 2 laser products that comply
with IEC60825-1:2007.
Although Class 2 laser light is only emitted momentarily, never look directly into
the beam light.
The laser light emitted by this laser scanner has a maximum output of less than
1 mW and a wavelength of 650 nm.
Use of controls or adjustments or performance of procedures other than those
specied herein may result in hazardous radiation exposure.
Bar Code Scanning Position
Position the laser scanner close to the bar code when scanning small bar codes.
Position the laser scanner at a distance from the bar code so that the bars enter the light
when scanning large bar codes.
Margin Margin
Good
Good Good
Bad
Bad Bad Bad
Warning!
■
Never look directly into the laser light.
The products with the integrated Laser Scanner module scan bar codes using
laser light. Never look directly into the laser light or shine the laser light
into the eyes.
•
•
•
•
•