1 USB Client Port This port is used to transmit data and les (download, upload) by
connecting the Cradle to a PC using a USB cable (DT-380USB-A).
A dedicated driver must be installed in the PC before connecting
the Cradle to the PC.
2 USB Host Port This port is used to connect a corresponding USB peripheral
device.
3 Power Switch Turns the power on and off.
4 Selector Switch This switch is used to switch between the USB host port and
USB client port.
5 AC Adaptor Jack Connect the AC adaptor here.
6 Terminal Detect
Switch
This switch detects when the DT-X100 is seated correctly on the
Cradle.
7 Power Contacts Power is supplied to the DT-X100 via these contacts.
8 Data
Communication
Terminal
Used for USB communications.
9 Power LED This LED indicates the power status and the mounting status of
the DT-X100.
Off: DT-X100 is not installed. Or, the AC adaptor is not
connected.
Green: Power on, DT-X100 mounted correctly.
10 Mount Hooks Use these hooks to lock the DT-X100 into the cradle.
To Next Page
Loading...
