1 USB Client Port This port is used to transmit data and les (download, upload) by
connecting the Ethernet Cradle to a PC using a USB cable
(DT-380USB-A). The dedicated driver must be installed in the
PC before connecting the Ethernet Cradle to the PC.
2 USB Host Port This port is used to connect a corresponding USB peripheral
device.
3 Power Switch Turns the power on and off.
4 Selector Switch This switch is used to switch between a USB connection and a
LAN connection.
5 LAN Connection
Status LED
This LED shows the status of the LAN connection.
Off: LAN cable not connected correctly.
Lit green: LAN cable connected correctly.
6 LAN
Communication
Status LED
This LED shows the LAN operation status.
Off: No communication.
Blinking green: Communication in progress.
7 LAN Port This port is used for connecting the cradle to a PC or hub via a
LAN cable so that data and les can be transmitted (uploaded or
downloaded).
The special driver software must be installed in the DT-X100.
8 AC Adaptor Jack Connect the AC adaptor here.
9 Terminal Detect
Switch
This switch detects when the DT-X100 is seated correctly on the
Ethernet Cradle.
10 Power Contacts Power is supplied to the DT-X100 via these contacts.
11 Communication
Terminal
Used for communications.
12 Power LED This LED indicates the power status and the mounting status of
the DT-X100.
Off: DT-X100 is not installed. Or, the AC adaptor is not
connected.
Green: Power on, DT-X100 mounted correctly.
13 Mount Hooks Use these hooks to lock the DT-X100 into the cradle.
To Next Page
Loading...
