Important !
Never short out the power contacts of the Cradle-type Dual Battery Charger.
This can damage the Cradle-type Dual Battery Charger.
Allowing the power contacts become wet can cause an electric shock or re. In
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.
Place the Handheld Terminal in the Cradle-type Dual Battery Charger. Check
the Indicator 1 on the terminal to ensure that it has been securely positioned in
the charger. The indicator will light up in orange for correct positioning.
Each unit of the charger comes with one piece each of the side and bottom brackets.
After you join two chargers together using these two brackets, one side bracket and
one bottom bracket will be left over. Keep these as spare for use in future.
Before linking multiple Cradle-type Dual Battery Chargers, be sure to
disconnect the AC adaptor.
Turn off the power on DT-X100 before placing it in the charger.
Place the Cradle-type Dual battery charger on a at, level surface and take care
when placing the DT-X100 in or removing it from the cradle.
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General