148
Using the Camera with a Computer
IMPORTANT!
• The camera does not support operation with Mac OS X 10.0. Operation is
supported with Mac OS 10.1, 10.2, 10.3, 10.4, 10.5, and 10.6 (using the OS
standard USB driver) only.
. To connect the camera to your computer and save files
1. Turn on the camera and press [MENU].
2. On the “Set Up” tab, select “USB” and then press [6].
3. Use [8] and [2] to select “Mass Storage”, and then press [SET].
4. Turn off the camera and then use the USB cable that comes with the
camera to connect it to your Macintosh.
The camera will turn on automatically and battery charging will start (page 19).
• The camera may not turn on automatically in the case of certain computer
models or connection conditions. If this happens, press [ON/OFF] (Power) to
turn on the camera.
• Make sure that you insert the cable connector into the USB/AV port until you
feel it click securely into place. Failure to insert the connector fully can result in
poor communication or malfunction.
Connecting the Camera to Your Computer and Saving Files
USB port
Making sure that the 6 mark on the camera is aligned
with the 4 mark of the USB cable connector, connect
the cable to the camera.
[USB/AV] port
Large connector
Small connector
Terminal
cover
USB cable (included with camera)
To Next Page
Loading...
Need help?
General
