72
Advanced Settings
. To change Auto Shutter trigger sensitivity (Sensitivity)
1. Use [8] and [2] to select “Sensitivity” and then press [6].
2. Use [4] and [6] to select the sensitivity setting you want, and then
press [SET].
• You can select any one of three sensitivity levels, from /.. (Lowest) to
/// (Highest).
• With the /// (Highest) setting, the auto shutter release is triggered relatively
easily. Auto shutter release triggering becomes more difficult with the /..
(Lowest) setting, but recorded images have the least blur. Experiment with
Auto Shutter trigger sensitivity settings to find the one that work best for you.
. Using Auto Shutter in Combination with Continuous Shutter
The following describes how Auto Shutter works while used in combination with
Continuous Shutter (page 43).
Tips for Better Auto Shutter Snapshots
• Using Auto Shutter in combination with Anti Shake (page 67) reduces the chance
of image blur even more.
• While recording with Detect Blur or Detect Smile, keep the camera as still as
possible until the recording operation is complete.
With CS: Normal
Speed CS, CS: 4 fps,
and CS: 10 fps
The camera will go back into Auto Shutter standby and be
ready to shoot again each time it is triggered. To stop an
ongoing Continuous Shutter operation, wait until “0 Auto”
is flashing on the monitor screen, and then press [SET].
With CS: Flash
3 continuous shutter images will be shot with flash when
Auto Shutter is triggered.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
