E-43
IR Communication
IR communication can be used to transfer
data between two Handheld Printer
Terminals.
When performing IR communication,
orient the IR ports of both Handheld
Printer Terminals so they are pointing
directly at each other.
Data communication is possible within a
distance of 0 (in direct contact) to 1 m
(max. 20 cm at 4 Mbps).
Important!
• A high-sensitivity communication element is used during IR communication.
• In order to ensure successful communication, avoid using cellular phones or
other devices that emit radio wave in the area where you are performing IR
communication.
• If you need to use such a device, move away from the communicating Handheld
Printer Terminals. In case of a cellular phone, keep it at least 30cm (
11
77
77
7
⁄⁄
⁄⁄
⁄
88
88
8
") away.
RS-232C Communication (IT-3100M53E/IT-3100M54E only)
You can also transfer data directly between
the Handheld Printer Terminal and your
computer. With the power turned off, open
the connector cover ( ) and connect the
RS-232C interface connector on the right
side of the Handheld Printer Terminal ( )
with your computer using the RS-232C
Cross Cable (HA-B80AX).
1
2
Performing Data Communication
1
2
To Next Page
Loading...
Need help?
General
