EN-44
Editing an Arpeggio
1.
On the MENU screen, touch “ARPEGGIATOR”.
2.
On the ARPEGGIATOR screen, touch “Edit”.
This displays the ARPEGGIATOR EDIT screen.
3.
Touch “Parameter Edit”.
4.
Configure parameter settings as required.
• Touch a display item and then select from the list that appears. Use the 9 w/NO, q/YES buttons to change setting
values.
* This editing operation can be performed on a step type arpeggio only.
5.
After you are finished editing the arpeggio, touch bo EXIT to return to the ARPEGGIATOR EDIT
screen.
6.
Save the edited arpeggio using the procedure under “To save an edited arpeggio” (page EN-45).
To change an arpeggio parameter setting
Item Description Setting
Max Step Maximum steps.* 1 to 16
Step Size Step size. Specifies the note length between steps. 2, 6, , 7, , 8
Note Length Note length. Specifies the length of the note to be sounded, as a percentage of
the step size. 100% specifies the same size as the step size, while 50% specifies
half the step size.
1 to 100%
Groove Groove. Specifies the on note timing of the off-beat step. 50% specifies even,
while a larger value increases the first half note length.
10 to 90%
Groove Type Groove type. Specifies the note length type when anything other than 50% is
specified for Groove.
Normal: Playback performed with step length based on actual percentage.
Short: When step length is changed, adjusts the step to the shorter length.
Normal, Short
Velocity Velocity. Specifies the velocity value of the arpeggio to be input. Specifying
“Key On” inputs a velocity value in accordance with applied key pressure.
Key On, 1 to 127
Hold Pedal Hold pedal. Turns the hold pedal effect on or off.
When on, the hold pedal effect is applied to the arpeggio.*
Off, On
Control Track Control track. Enables or disables use of control data.* Off, On
Control Type Control type. Specifies the control data type.* Pan, Filter
Smooth Smooth. Selecting “On” causes control data to be supplemented for playback.* Off, On