SE-S100 / PCR-T285 / PCR-T295
– 26 –
[6] SD Card Test (write / read, report)
<6-1. SD Card Write/Read Test>
[Function]
Writes the text fi le for the test (test.txt) on the SD card and tests whether the written fi le can be read.
[Important]
• Use an SD card formatted as FAT32.
• Insert the SD card before the starting test.
• The test result shows “NG” if you use a write-protected SD card.
• The text fi le written during the test (test.txt) will not be erased.
• If the SD card contains a fi le with the same name (test.txt), delete “text.txt” fi le fi rst before
performing the SD card check.
[Operation]
Command :
n
0
1
4
o
n: Number of times to run
0 Once (can be omitted)
1 to 9 Infi nite loop (to forcibly terminate the test, press
y
.)
[Printout of the result]
RAC n014
SD WR OK
END n014
<6-2. SD Card Report>
[Function]
Prints out the memory size of the SD card and its write-protection status.
[Operation]
Command :
n
6
1
4
o
n: Number of times to run
0 Once (can be omitted)
1 to 9 Infi nite loop (to forcibly terminate the test, press
y
.)
[Printout of the result]
RAC 614
Size = XXXX MB
WriteProtect = OFF
SD SIZE OK
END 614
To Next Page
Loading...
Need help?
General
