E-28
Sounding Arpeggios Automatically (Tutorial)
Use the procedure below to clear preset step data or
step data that was edited using Step Edit (page E-25)
and create new step data from scratch.
• Note that the variation type cannot be cleared.
1.
While the arpeggio type selection screen is
displayed, press the
ep
(EDIT) button.
2.
Use the
dt
(w) and
ek
(q) buttons to select
“Clear Step” and then press the
em
(ENTER)
button.
This should cause “Clear?” to appear on the display.
3.
Press the
em
(ENTER) button again.
This will display a confirmation message (“SURE?”).
4.
Press the
eo
(YES) button.
The message “Complete!” will appear on the display
when the data is deleted.
After editing an arpeggio, you can give it a name and
save it as a user arpeggio.
1.
Perform steps 1 through 2 of the procedure
under “Editing an Arpeggio”, (page E-25).
2.
Use the
ds
(u),
dt
(w),
ek
(q), and
el
(i) buttons to select “NameEdit”, and then
press the
em
(ENTER) button.
3.
Edit the name as desired.
Clearing Arpeggio Step Data
Renaming an Arpeggio
To Next Page
Loading...
