EN-20
Recording and Playback
Playing Back from Digital Piano Memory
1.
Press the MIDI REC button so its lamp is lit.
• When a song has something recorded in both tracks,
you can turn off one track and play back just the
other track, if you want.
2.
Press the a button.
• This starts playback of the song and/or track you
selected.
• You can change the tempo setting as a track is
playing.
• Press the a button again to stop playback.
Deleting Recorded Data
The following procedure deletes a specific track of a
song.
• The procedure below deletes all of the data of the
selected track. Note that the delete operation cannot
be undone. Check to make sure you really do not
need the data in Digital Piano memory before you
perform the following steps.
1.
Press the MIDI REC button once or twice so
the MIDI REC lamp is flashing.
2.
While holding down the FUNCTION button,
press the a button to select the track you
want to delete.
3.
Press the MIDI REC button until its lamp is lit.
• This will cause the lamp of the track you selected in
step 2 of this procedure to flash.
Example: If you selected Track 2 for deletion
4.
Once again, hold down the FUNCTION
button as you press the a button.
• This deletes the selected track and enters record
standby.
• To cancel the delete operation at any time, press the
MIDI REC button so its lamp becomes unlit.
• Only the Digital Piano’s a button are operational
from step 3 until you actually perform the delete
operation in step 4. No other button operation can be
performed.
Off Flashing: Delete standby
To Next Page
Loading...
Need help?
General
Weight and Dimensions
