Assembling the Stand
E-37
3.
With the speaker box C laying on its side as
shown in the illustration, secure side panels
A and B to the speaker box C. Secure the
side panels using four screws D.
• Align the screw holes of the speaker box C with the
screw holes of the side panels as you install the
screws D.
• Partially tighten the screws on one side of the speaker
box C and then fully tighten the screws on the other
side.
• Next, fully tighten the screws that you partially
tightened.
• You can also install the speaker box C so it faces
towards the back of the stand.
4.
After ensuring that all of the screws are fully
tightened, remove the packing material and
stand up the stand.
• Cover each of the eight side panel screws with screw
caps E.
• Insert screw caps at the locations indicated in the
illustration and press them in as far as they will go.
5.
Attach the brackets I to the pedal unit F,
and temporarily secure them with screws G.
6.
Remove the screws that hold the corner
brackets in place on the back corners (the
corners away from the pianist) of the side
panels.
C
A
D
D
E
E
I
-(a)
I
-(b)
F
G
PX800_e.book 37 ページ ２００６年１０月１２日 木曜日 午後１２時５分
To Next Page
Loading...
Need help?
General
