49
Note 1:
This parameter sets the SysEx Device ID.
Tune / Mix Parameter
Note 1:
See "43.7 -99 to 0 to 99 Setting Value Table".
Note 2:
See "43.4 -24 to 0 to 24 Setting Value Table".
Note 3:
See "43.6 Pan Setting Value Table".
Note 4:
This specifies the volume of data sent from System Chorus to System Reverb.
Note 5:
When "DSP Bypass" is specified for "DSP Line Bypass," the DSP Line Select settings of all parts are cancelled, and all
DSP lines are treated as if they are turned off. This means that notes that are currently sounding are not affected.
Drawbar Parameter
Note 1:
See "10.20.3 Drawbar Position" for information about index numbers.
Note 2:
See "43.18 Drawbar Percussion Setting Table" for information about percussion setting values.
ParamID Parameter bit Value Default Setting Value (Decimal)
04
Master Fine Tune (Note 1)
08 00-FF 80 -100 to 0 to 99cent
05
Master Coarse Tune (Note 2)
07 28-58 40 -24 to 0 to 24semi
08 Master Volume 07 00-7F 7F 0-127
09 Master Pan (Note 3) 07 00-7F 40 -64 to 0 to +63
0A
Chorus Send To Reverb (Note 4)
07 00-7F 00 0-127
0B DSP Line Bypass (Note 5) 01 0-1 0 0...Effect
1...DSP Bypass
ParamID Parameter index bit Value Default Setting Value
(Decimal)
0C Bar Position
Bar Num (Note 1)
02 0-3 0 0-3
0D Percussion 0 02 00-03
(Note 2)
00
off,2nd,3rd,2nd+3rd
0E
Percussion Decay Time
0 07 00-7F 28 0-12.7sec
0F Click 0 01 0-1 00 0...Off
1...On
To Next Page
Loading...
Need help?
General
