— 19 —
Message on LCD
12. LCD check
1 Press “TEMPO UP” button.
* Turn on all segments.
13. LED check
1 Press “TEMPO DOWN” button.
* LEDs illuminate in the following order.
All turn on Echo Full Range Fingered CASIO Chord Data Access Drawbar DSP
14. CARD check
1 Inset the SD card.
2 Press “-” button. SDC_CHK
3 It takes about 3 minutes until “CARD_OK” is displayed. CARD_OK
4 Remove the SD card.
15. DIAGNOSTIC PROGRAM IS FINISHED
1 Press “EXIT” button.
* Exit to normal operation mode.
To Next Page
Loading...
Need help?
General
