18 Scanning
18.1 About Item code and Scanning code
In item settings, there are two ways which are item code setting and scanning code
setting. Item master key (primary key of database) is item code.
In normal item key registration, the item is registered according to item code, but in
scanning (barcode scanning by scanner or OBR key manual input) operation, the
item is registered by searching item master’s scanning code
Scanning code is used only for scanning. After registrations, item code is used for
data aggregation or data report. In an operation that item code is irrelevant, it is
useful that you set the same code on item and scanning codes. However, as
automatic learning operation assigns item code automatically, set value “1” in
“SALES.NFP.ITEMCODE.SCANCODE (Reserved by defaulted)” of Operation
setting. Same code as scanning code is used as item code.
18.2 NFP（Not Found PLU）
Auto learning (Not Found PLU) feature adds scanning code data in the item master
when scanned code is not set in item master.
As it is necessary for auto learning registration to determine unit price and item
settings of added item, it is selected by the settings of auto learning system. Though
the default of auto learning setting seems to select from department, you can select
any object than department freely.
127
To Next Page
Loading...
Need help?
General
