19.3.2 Re-connect to master
Reconnect to master after standalone mode, below operation is required. Restart
cash register application without below operation, satellite connect master
automatically and it can not get check data inside satellite.
1. Check as standalone mode.
Check [Network Error] message top-right on screen.
2. Open check X and check data.
Issure open check X on satellite and master terminals.
Data inside only satellite:
Finalize the check on satellite or create same data on master terminal.
Data inside both satellite ans master:
Check the both data and judge which data is correct. If satellite data is correct,
finalize the data on satellite or create same data on master. If master data is
correct, no operation is required.
3. Open check Z
Check [Network Error] message top-right on screen.
Open check Z on satellite terminal.
4. Restart cash register application.
Restart cash register application.
Check [Network Error] message has been cleard.
5. Open check X
Issure open check X on satellite terminal. If check data exists on report, please
confirm the data came from master terminal. Check data terminal number shows it
came from master terminal.
[Network Error] message is available from Ver4.3.3. If you use older version
please ignore the message explanation.
135
To Next Page
Loading...
Need help?
General
