WK-240
– 21 –
DIAGNOSTIC PROGRAM
Y
Preparation
(1) Connect the AC adaptor.
[NOTE] The AC adaptor for the WK-240_DI and WK-240_UK is sold separately.
[NOTE] If you do not have the AC adaptor, use six D-size dry batteries with enough capacity.
If you use the batteries, do not perform the “AC Adaptor Check”.
(2) Adjust the main volume so that it is at about 1/3 of the full volume.
(3) Have a pedal (SP-3 or SP-20) ready.
[NOTE] SP-3 and SP-20 are sold separately.
The “Pedal Check” cannot be performed without a pedal.
(4) Have a PC and USB cable ready.
[NOTE] Please refer to the User’s Guide for PC system requirements.
[NOTE] The “USB Check” cannot be performed without a PC and a USB cable.
Y
How to Start the Diagnostic Program
(1) Turn on the power while holding down the [0], [1] and [2] buttons.
[NOTE] When the test is fi nished, be sure to press the power button to turn off the power.
(2) Release the [0], [1] and [2] buttons.
When the diagnostic program is launched, the Test Mode screen appears.
To Next Page
Loading...
