Casio XJ-A130 - Powering On;Off and Language Setup

E-17
Getting Ready
English
You can use the projector to project an image of analog RGB output from a computer.
Important!Important!Important!
 Always turn off the projector and the computer before connecting them.
 Take care so the volume level of the computer is not set too high.
You can use the projector to project an image from a video deck, TV, video camera, or other video
device.
Important!Important!Important!
 Always turn off the projector and the video device before connecting them.
 You can use the bundled special AV cable to connect to a pin jack (RCA) type VIDEO output terminal.
When connecting a video camera or other video device with a special video output terminal, use the
special cable that comes with the video device. For details, see the documentation that comes with
the video device.
NOTE
For details about the following types of connections, see the User’s Guide on the CD-ROM that comes
with the projector.
 Projector and component video output of video device
 Projector and HDMI output of video device or computer
Connecting a Computer to the Projector
Connecting to a Standard Video Device
<Projector> <Computer>
Bundled mini D-Sub cable
Audio cable (commercially available)
AV terminal
To monitor terminal
(analog RGB output terminal)
COMPUTER terminal
To line output terminal
<Video device>
Bundled special AV cable
<Projector>
Yellow
Red
To VIDEO output terminal To AUDIO output terminals
White
AV terminal