Casio XJ-A130 User Manual

E-27
Troubleshooting
English
Important!Important!Important!
 Try performing the following steps, which may or may not return the projector to normal
operation.
 If normal operation does not resume after you perform the above steps, take the projector to
your retailer or authorized CASIO service center.
The remote controller
does not work.
The remote controller batteries may be dead.
➔ Replace the batteries (see “Replacing Remote
Controller Batteries”).
page E-13
The remote controller may be too far from the projector.
➔ Make sure the remote controller is within the
allowable range when you operate it.
User’s Guide
(UsersGuide_
English.pdf)
The TEMP or LAMP
indicator is flashing or
lit.
➔ See “Error Indicators and Warning Messages”. User’s Guide
(UsersGuide_
English.pdf)
Lamp does not light. The lamp may be defective.
➔ Contact your original dealer or authorized CASIO service center for
replacement.
1. Unplug the AC power cord and wait for at least 10 minutes.
2. Plug the power cord back in and turn the projector back on again.
Problem Cause and Recommended Action See

Casio XJ-A130 Specifications

General

Matrix size	0.55 \
Number of colors	16.78 million colors
Projection distance	2.8/5.6 m
Projection technology	DLP
Contrast ratio (typical)	1800:1
Screen size compatibility	15 - 300 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-30/30 °
Focus	Manual
RMS rated power	1 W
Number of built-in speakers	1
Dimensions (WxDxH)	297 x 210 x 43 mm
Power requirements	AC100-240V, 50/60Hz
Connectivity technology	Wired
Microphone in	Yes
Serial interface type	RS-232
Power consumption (standby)	0.4 W
Power consumption (typical)	190 W
Product type	Standard throw projector

Weight and Dimensions

Weight	2300 g