Cassese CS 79 - Putting Into Operation; Unpacking and Reassembly

CLOSING CLIPS
OPENING CLIPS
S1 S2
AX
Fig E
AX
M
EA
Fig D
PUTTING INTO OPERATION
CP
3
Fig H
Fig F
Fig G
BOTTOM
PULLEY
M
1 ) UNPACKING & REASSEMBLY
Ta
Fig B
fig.A
B
Fig C
Po
P
BP
BF
- Keep the package of the machine so, that the arrows drawn on the outside stand up, (see Fig A)
- Open the parcel. Remove machine’s table Ta and the foam protection (see Fig. B).
- (See Fig C) Pressing down the crossing wood piece B, loosen and remove one of the two feet of
the machine that are holding the wood piece B in place. The wood piece B is pushed up by the
machine’s top presser; therefore remove it slowly until the machine’s top presser is completely
free. Fix the removed foot back on machine.
- Remove the foot pedal P and the accessory box now. (See detail of content page 5)
- Remove the turning upper cabinet BP and the bottom cabinet BF. (Fig.C)
- The bottom cabinet BF is upside down; put it right on its feet.
- Place the upper cabinet BP on the bottom cabinet BF.
- Close the locking clips as shown on Fig.D.