CASTLE Serenity - Specifications

9
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
Operator's Manual
Serenity Pellet Stove
ENGLISH
SPECIFICATIONS
Model Number Serenity
BTU/hour input (1) 4.0 lbs/hr
Heating Capacity (2) 1,500 sq. ft.
Electrical Rating (3) 115 Volts, 60 Hz
Power Consumption 402 Watts ignition
77 Watts operating
Fuel Storage Capacity 40 lb
Flue Size (4) 3 in.
Width 18.25 in.
Height 34 in.
Depth 23.75 in.
Weight 186 lb
(1) Heat output will vary, depending on the brand, type and
quality of fuel and the moisture content. Consult your
dealer for best results.
(2) Based on post 1982 home construction, requiring 35
BTU/Hr. per Sq. Ft.
(3) Install per NFPA 70 and follow all state and local codes,
contact licensed electrical contractor for assistance.
(4) Install per NFPA 211 and follow all state and local codes,
contact licensed installers for assistance.
Listing label:
Tested to the following standards: UL1482, ASTM E1509, ULC/
ORD-C1482-M1990, UCL S627-2000, and E2779
Glass Specications:
This stove is equipped with 5 mm ceramic glass. Replace glass
only with Castle Pellet Stoves ceramic glass. Call your servicing
dealer or Castle at 1-800-345-6007 for replacement parts.
UNPACKING
Your Castle Serenity will come fully assembled. Remove all
packing material and tape from the inside of the rebox. Remove
any tape on the outside of the glass. Open the hopper, remove all
packing material and power cord.
THIS INSTALLATION MUST CONFORM WITH
LOCAL CODES. IN THE ABSENCE OF LOCAL CODES
YOU MUST COMPLY WITH ASTM E1509, UM 84
HUD, ULC/ORDC1482 AND AND UCL S6272000.
CASTLE PELLET STOVES, MANUFACTURER OF
THIS APPLIANCE, RESERVES THE RIGHT TO ALTER
ITS PRODUCTS AND/OR THEIR SPECIFICATIONS
WITHOUT NOTICE.
MAKE SURE THE HOPPER IS FREE OF ALL FOREIGN
MATTER BEFORE FILLING WITH FUEL. FOREIGN
MATERIAL WILL CAUSE AUGER JAMS AND WILL
VOID STOVE WARRANTY.
CAUTION