Alternatively, consider using the Frequent Feed option described in section 13.
Set the meal sizes for each programmed meal time as follows:
1. Press and hold the `FEED’ button for 5 seconds. The letter `F’ next to two zeros (`00′) will appear and flash on
the display (Fig. 8). Press the `+’ or `-‘ buttons to set the number of feed units for this meal setting.
2. Press the `FEED’ button again to set the meal sizes for `MEAL 2′ (and `MEAL 3′).
NOTE: Programming the feed units to two zeros (`00′) denotes that the feed unit is set to `off’ and the meal
indicator will not be displayed when this procedure is completed.
3. When all meal sizes are programmed, save your settings by pressing the `FEED’ button.
Once the settings are saved, the clock indicator will be shown and the programmed meal indicators will be
displayed under the respective food bowl icons (Fig. 2). The indicator representing the next meal time due to be
served will flash.
Reviewing meal sizes
When the clock indicator is showing you can review all your programmed meal size settings as follows:
1. Press the `FEED’ button – the programmed feed units set for `MEAL 1′ will display for 60 seconds.
2. Press the `FEED’ button again within 60 seconds to view the programmed feed units for `MEAL 2′ and again for
`MEAL 3′.
3. Press the `FEED’ button again to return to the clock display.
Setting meal times (Not required for Frequent Feeding option – go to section 13)
1. Press and hold the `TIME’ button for 5 seconds until the hour figure on the clock starts to flash.
2. Press the `TIME’ button twice – the hour figure and the `MEAL 1′ indicator will flash.
3. Set the mealtime in the same way as setting the clock, by pressing the `+’ or `-‘ buttons to adjust the hours,
press the `TIME’ button again and adjust the minutes.
4. When the desired meal time is displayed press the `TIME’ button. Repeat 8.3 to set `MEAL 2′ and `MEAL 3′.
NOTE: If only one (or two) meals per day are required, the setting for `MEAL 2′ (and `MEAL 3′) are not critical.
5. When all mealtimes are programmed, save your settings by pressing the `TIME’ button repeatedly until the
clock indicator displays (after `MEAL 3′). 5
Reviewing meal times
When the clock indicator is showing you can review all your mealtime settings as follows:
1. Press the `TIME’ button to display the programmed mealtime set for `MEAL 1′.
2. Press the `TIME’ button again within 60 seconds to view the programmed meal times for `MEAL 2′ and again
for `MEAL 3′.
3. Press the `TIME’ button again to return to the clock display.
Extra feed (in addition to a Set Meal)
If you would like to serve your pet additional units of food at any time, press the `FEED’ and `+’ buttons together. The
feeder will dispense one unit of food. To serve a number of units, keep both buttons held down and the LCD will
display the total number of units dispensed. Release both buttons and the unit will complete its current feed unit. The
number of units dispensed will remain displayed for 60 seconds. 1
Advance feed (serving the next Set Meal early)
If you would like to bring a programmed set meal forward, press the `FEED’ and `-‘ buttons together. The feeder will
dispense the next programmed meal due and you may now release both buttons. Once the advanced set meal (e.g.
MEAL 2) has been served the next programmed meal indicator (i.e. MEAL 3) will flash on the display and food will
not be dispensed until that set time. You may only advance meals programmed for the same day.
Manual feed (dispensing controlled feeds on demand)
To Next Page
Loading...
