Catler CM 4012 - Manual Coffee Brewing

10
OPERATING YOUR CM 4012 COFFEE MAKER
to slowly dispense water through the
opening hole in the centre of the water
tank bottom. There is arotary mechanism
under the opening hole which will rotate
while dispensing water to evenly brew
the grounded co ee.
10. After awhile, the co ee maker will
stop dispensing water and the co ee is
brewed for about 30seconds.
11. Then, the water dispensing starts again,
and the co ee maker will repeat this
process until the total amount of water
weighs 15times more than the grounded
co ee.
12. Once the adequate amount of water has
been dispensed, the rotary mechanism
will stop. The display will show the total
co ee amount.
13. Wait until all co ee has dropped down
into the carafe, then carefully remove the
 lters, and place the stainless-steel  lter
into the holder where you leave it to cool
down.
WARNING!
The stainless-
steel filter, brewed
grounded coffee
and carafe are
very hot. Pay more
attention when
handling, not to get
scalded.
MANUAL COFFEE BREWING
1. Pour clean and cold water into the water
tank. Always observe the minimum and
maximum marks which are marked on
the tank.
2. Place the stainless-steel  lter into the
carafe neck and place a“V”-shaped
paper  lter, size 4, suitable for drip-co ee
machine, into it, and insert the carafe into
the co ee maker.
NOTE
Paper  lters are not included in
the packaging and these can be
purchased at aregular retailer.
3. Turn the rotary know to the “Brew Mode
A/M” position. The indicator light will
be lit. Use the / buttons to select
“MANUAL” (manual co ee brewing).
4. Press the TARE button and then, remove
the carafe from the co ee maker.
5. Put the required amount of the grounded
co ee into the paper  lter. Ensure you
use the grounded co ee for drip-co ee
machines. The amount of co ee depends
on your personal preferences.
6. Place the carafe back into the co ee
maker and the display will show the
weight of the grounded co ee.
7. Now, set the parameters of the drip-
co ee.
Water temperature: Turn the rotary
knob to the “Temp” position. The
indicator light will lit. Use the /
buttons to set the brewing temperature
in the range from 80°C to 98°C. Press
the  button or wait till the data on the
display will stop  ashing.
Co ee-to-water ratio: Turn the rotary
knob to the “C/WRatio” position (ratio of
the grounded co ee to water).