Catler CM 4012 - Delay Start of the Coffee Maker - Manual Brewing Coffee; Hot Water Dispensing; Descaling; Automatic Stand-By Mode

12
OPERATING YOUR CM 4012 COFFEE MAKER
display will show only “PROG”.
5. Once the clock on the display shows
the set time, the co ee maker will start
the brewing process following the set
parameters.
DELAY START OF THE COFFEE
MAKER  MANUAL BREWING
COFFEE
1. Follow the 1. – 7. steps from the “Manual
co ee brewing” part.
2. Turn the rotary knob to the “Program”
position and the display will show the
last delay start setting.
3. Use the / buttons to set the time
when the co ee maker starts brewing.
Follow the same steps as setting
the clock. Press the  button for
con rmation.
4. Press the  button to turn on the co ee
maker and the delay start function. The
display will show “MANUAL” and “PROG”.
That means the correct setting of the
delay start. After awhile, the co ee
maker will show the actual time and the
display will show only “PROG”.
5. Once the clock on the display shows
the set time, the co ee maker will start
the brewing process following the set
parameters.
HOT WATER DISPENSING
1. Pour clean and cold water into the water
tank. Always observe the minimum and
maximum marks which are marked on
the tank.
2. Place the carafe under the water
dispensing vent. There is no need to
place the stainless-steel or paper  lter in
this mode.
3. Turn the rotary knob to the “Hot Water”
position. The display shows the current
temperature in the water tank.
4. Use the / buttons to set the
water temperature to which the
co ee maker is to heat the water (set
ahigher temperature than the actual
temperature).
5. Press the  button to turn the co ee
maker on. The co ee maker will start to
heat the water and the display will show
the actual water temperature in the
water tank.
6. Once the temperature reaches the set
level, the co ee maker will stop heating
and start to dispense the whole amount
of the hot water in the water tank into
the carafe.
DESCALING
1. The descaling indicator light will  ash
after 50 brewing cycles.
2. Pour clean water into the water tank up
to the Max mark and add the required
amount of citric acid.
3. Turn the rotary knob to the “Clean”
position. The display will show “100°C”.
4. Press the  button and the co ee maker
will start heating the water. The display
will show the actual water temperature.
5. Once the temperature reaches the set
level, the co ee maker will stop heating
and start to dispense hot water until the
water tank is empty.
6. If the descaling indicator light stops
 ashing, the descaling process will be
 nished.
AUTOMATIC STANDBY MODE
When the co ee maker is on and there
is no activity within 30seconds, it will
automatically switch to the stand-by mode
and the  button illumination will turn o .
Turn the rotary knob or press any button
the cancel the stand-by mode. Once the 
button illumination is on again, the co ee
maker is ready to use.