Change RAID Settings
There are two ways to change the RAID settings. We recommend you use
the SteelVine software included with your product; however, an alternative is
using the "0-7 Settings Dial" (p.17). Changing the RAID settings will result in
loss of data currently stored on the drive. After configuring RAID settings,
you will need to partition and format your drive (p.20).
I. Using the SteelVine (GUI) software (In order to use GUI, your unit's "0-
7 Settings Dial" must be set to "7," which is the factory default)
Step 1. Turn the product on.
Step 2. Open the Resources CD in "My Computer," open the folder
"Contents/STEELVINE/" and open the folder corresponding to your operating
system. Install the "setup" file (Windows) or pkg file (Mac).
Step 3. Follow the on-screen instructions to install the software.
14 15
To Next Page
Loading...
