Press MENU button to show the FUNCTIONS window. Use the / buttons to move the
cursor to 2. Disc Capture and press button to select.
From the initial Welcome screen, press JB/CD button to switch from JUKE to
DISC (DISC1/DISC2) mode. Press OPEN/CLOSE button on the remote control to open the
disc drive and insert a CD+G or Audio CD disc into the disc drive (DISC1 or DISC2). Press
the OPEN/CLOSE button again to close the disc drive.
Do not use the OPEN/CLOSE button on the disc drive itself.
HOW TO OPERATE
Disc Capture
2
1. Select Drive (DISC1 / DISC2)
Select the disc drive which contains the disc you wish to capture.
2. Overwrite exiting data (Yes / No)
Select Yes if overwriting existing data.
3. Starting song number (xxxxx)
Select a starting number from which the captured songs will be stored. Normally it is set as
the last song number in the JB-199 unit. So the actual song number that would be assigned
is the Starting song number + 1. For example, if you wish to assign the number 15, 14
should be the Starting song number.
4. Conversion speed (1X, 2X, ..., 52X, DVD 1X, ..., DVD 20X, MAX)
Select the disc drive speed at which the disc will be read.
5. Compression rate (32Kbps, ..., 128Kbps, ..., 320Kbps)
Select the rate at which the audio data will be compressed. Normally it is set at 128Kbps.
42
2. Password (On / Off)
Press to enter and select On by pressing . Press to input your password (4 digits). Now
entry to MENU will require the password. Press MENU and “?” will show on the top left
corner of the LCD display. Input the password and the MENU window will open. To turn off
the password, go to 2. Password. Press to enter and input the password.
3. Register Song Files
Press to register all song files in JB-199. The system ID will be tagged to all song files inside.
6. Lyric Sync timing (-300 fr, +300 fr)
Select the delay timing of lyric display relative to music. 75 fr is equivalent to 1 second.
Normally it is set at 0.
To Next Page
Loading...
