Press MENU button to show the FUNCTIONS window. Use the / buttons to
move to 3. Disc Recording and press button to enter.
1. Select Driver (DISC1 / DISC2)
Press to enter. Select, using / buttons, the disc drive which contains the
blank CD-ROM.
2. Select File (All / Select)
Choose to write all tracks or some selected tracks only. If some, choose Select and
press . A new window SELECT FILE will appear. Use the / buttons to
move along the files and use button to select or unselect each file. When the
selection is complete, press to return.
3. Writing speed ( 1 / 2 / ... / 40)
Press to enter. Select a speed for recording. Normally, it is set at 8x.
4. Write files
Press to record the selected files onto the CD-ROM.
5. Delete files
Press to delete the selected files.
Disc Recording
3
This chapter describes how to make Audio CD from the recorded tracks.
From the initial Welcome screen, press JB/CD button to switch from JUKE to
DISC (DISC1/DISC2) mode. Press OPEN/CLOSE button on the remote control
to open the disc drive and insert a blank CD-ROM disc. Press the OPEN/CLOSE
button on the remote control again to close the disc drive.
HOW TO OPERATE
Do not use the OPEN/CLOSE button on the disc drive itself.
44
To Next Page
Loading...
