A. Encoding from CD+G discs
Encoding of song files from CD+G discs can be done in two ways:
* in a remote PC with a disc drive (CD+G compatible)
* directly in JB-199 connected with an external disc drive (CD+G compatible)
Note: For a list of CD+G compatible disc drives, see Chapter: External disc drive in
Section: Optional Devices.
Note: For instruction on how to encode from CD+G discs directly in JB-199, see Chapter:
Disc Capture in Section: Advanced Functions.
1. Using a remote PC with a disc drive (CD+G compatible)
- Install the CAVS JB-199 Manager program into the PC.
- Start the program and click on CDG ENCODER.
- Insert the CD+G disc into the disc drive and close the tray.
- Press SOURCE DRIVE button to select a disc drive, if there is more than one, which
contains the CD+G disc.
- Press READ TOC button to display the tracks of the CD+G disc in the left side panel.
- Press Target button to select a directory in which the encoded files will be stored.
- Select a track you wish to encode by placing a check mark and inputting a title. If you
wish to select all, press the Check All button and input a title.
Note: The files encoded will be named as the inputted titles. Assign a different title to
each track to avoid overwriting.
- Select a disc drive speed at which the CD+G disc will be read.
- Select the compression rate at which the audio data will be encoded. Normally it is set
at 128Kbps.
Preparing Song Files
1
HOW TO OPERATE
51
To Next Page
Loading...
