8
Using your hob
To switch the hob on
• To switch the power on, touch the "On/o sensor" (1)
for
approximately one second. The hob will beep, the zone displays
and the timer display will show dashes.
Please note: If a zone is not selected nor a power level set within one
minute, the hob will switch o automatically.
To set the power level
• Touch the zone selector (5) for the required zone. The hob will
beep and the zone display will show flash "0".
• Select the desired heat setting using the "+" or "-" selectors. The
power level ranges from 1 (minimum) to 9 (maximum). The power will
jump to 5 upon first touch of the '+' sensor. After a few seconds the
hob will begin heating.
Please note: After zone selection, zone adjustment will remain active
for approximately five seconds. Also, if no key is touched within one
minute, the zone will become inactive and the hob will switch o
automatically.
To turn the power o to a zone
• To switch o a zone, touch the zone selector (5) so that the cooking
zone display (4) flashes. Then use the "+" or "-" selectors to adjust
the power level to "0". The cooking zone indicator will display a "0"
to confirm that the zone is now inactive but will display an " " if the
zone is still hot to the touch.
To Next Page
Loading...
