17
Residual heat indicators
The hob is equipped with residual heat indicators to warn when any
of the zones are still hot to the touch after cooking. An “H” will show
in the relevant zone display after cooking until the zone is at a safe
temperature to touch.
In the event of a power cut, the residual heat indictors will illuminate
after the power supply is restored. However, when there is no power
supply to the hob the residual heat indicators will not work, so extra
care must be taken.
Please note:
You should avoid touching the zones when the hob is in use, or when
an “H” is showing on the zone display.
Small object safety
Anything left on the control panel (e.g. cutlery or towels) will cause the
hob to switch o automatically and “Er03” to show on the display.
Pan detection
The hob is equipped with a sensor that will advise when the pan is
removed from the zone, or is unsuitable for use on induction hobs.
The zone display will show “u” alternating with the power level until
a suitable pan is placed on the zone. The zone will switch o after
approximately one minute if no suitable pan is placed on the zone.
To Next Page
Loading...
Need help?
General
