CDA WC432 User Manual

8
Half load button and indicator light
The dishwasher is equipped with a half-load function that allows for
small numbers of dishes to be washed, spread between both baskets.
This reduces the amount of water and electricity used.
To use this function, press the half-load button (4). The indicator light
should illuminate and shows that this function is selected.
If you have selected the half-load function for a programme, then this
function will automatically be selected the next time the dishwasher
is used. To cancel the selection of this function, press the half-load
button (4) until the indicator light goes out.
Delay timer button and delay timer indicator lights
The dishwasher is equipped with a variable delay timer of three, six
or nine hours duration. To set the delay timer, press the ‘Delay Timer’
button (5). This will switch on the delay timer for three hours, and
the 3h light will illuminate. To change the duration, press the ‘Delay
Timer’ button again until the light next to the required time (6h or 9h)
is illuminated.
To cancel the timer, press the “Delay Timer” button again until none of
the “Delay Timer” indicator lights are illuminated.
As the delay timer counts down, the “Delay Timer Indicator” lights will
illuminate in turn, so at six hours delay the “6h” light will illuminate, and
at three hours delay the “3h” light will illuminate.

CDA WC432 Specifications

General

Brand	CDA
Model	WC432
Category	Dishwasher
Language	English