CDVI DGA - Reset Master Code; Audible Feedback

EN EN
DGA
Keypad DGA
7cdvigroup.com
F. Reset master code
On stand-by operating mode,
short the wires yellow and white.
- One beep is emitted.
 -WaituntilthegreedLEDlightisoff.
- Seperate the two wires.
 -Themastercodeisrestoredtoitsdefault 
value 1 2 3 4 5 in 5-digits code and 1 2 3 4
in 4-digits code.
G. Changing the code by a user
To authorize a user to modify its own
user code connect together the yellow
and blue wires.
1. Enter the old user code.
The relay is activated and a beep is emitted.
2. Enter the 2-digits sub master code
(default sub master code AB).
Abeepisemittedtoauthorizemodication.
3. Enter the new user code.
2beepsareemittedtoconrm
the new code.
4. Check the new user code to be sure
   ofthemodication.
H. Setting a sub master code
The Sub Master code allows the user
to change its own code without entering
in programming mode. For security
reasons the code need to be changed
periodically. This feature makes it easier
and faster to change its code.
1. Enter the master code twice
(1 2 3 4 5 defaultvaluemastercode).
   2beepsareemittedtoconrmentry
in programming mode.
2. Press A7 to program a sub master
code for the user individual Pin
   codemodication.
(Press A8 for relay 2)
- One beep is emitted.
- Enter the new 2-digits sub master code.
  -Onebeepisemittedtoconrm
   programmingofthesubmastercode.
3. Press B to exit from
the programming mode.
2beepsareemittedtoconrmthatthe
keypad is in stand-by operating mode.
I. Audible Feedback
The audible signal is enabled in programming
mode and when the relay is energised
after a valid code. To enable the audible
feedback on a key press:
1. Enter the master code twice
(1 2 3 4 5 defaultvaluemastercode).
   2beepsareemittedtoconrmentry
in programming mode.
2. Press AA.
- One beep is emitted.
- Press 0 to disable the audible signal
during a keypress.
- Press 1 to enable the audible signal
during a keypress.
  -Onebeepconrmsthenewsetting.
3. Press B to exit from
the programming mode.
2beepsareemittedtoconrmthatthe
keypad is in stand-by operating mode.