cecotec Conga 1090 Series - 6. Battery Charging and Replacing

ENGLISH
26
Clean the main brush::
1. Slightly press the main brush frame’s tabs in order to open the main brush storage gap
and to remove the main brush
2. Remove any hair, fluffs or dust collected in the brush and around the axles.
3. Clear and clean the robot’s suction channel.
4. Reinstall the main brush and its frame.
5. The device has two brushes:
• 2 materials brush for intensive cleaning
• Silicone brush for hard floors and special for animals.
6. BATTERY CHARGING AND REPLACING
• To lengthen the battery’s service life, keep the robot charging on the charging base
when not in use.
• If the robot is not going to be used for a long period of time, remove the battery and
store the product and the battery in a safe and dry place.
In order to replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery compartment, remove the battery cover and the
battery.
2. Insert the new battery with the battery label facing up.
05110_Conga 1090 Excelsior_Manual_GC_DS.indd 26 27/6/18 21:02