cecotec Conga 1090 Series - 7. Troubleshooting

ENGLISH
27
3. Place the battery and the battery cover in its place and fil properly de screws back again.
7. TROUBLESHOOTING
Robot signal Cause Solution
Red light
solid
1 beep Omnidirectional wheel error Clean the side brushes and press
the power button to restart the
robot
2 beeps Robot's side brush error Clean the side brushes and press
the power button to restart the
robot.
3 beeps Motor fan or filter error Remove and empty the dust tank.
Remove the robot’s filter and shake
off any dust rests.
4 beeps Main brush error Remove and clean robot’s main
brush
05110_Conga 1090 Excelsior_Manual_GC_DS.indd 27 27/6/18 21:02