CONGA 1790 | 27
ENGLESK
Direct exposure to sun light or great light contrasts may aect to the cor-
rect operating of the sensors. If this happens and the robot stops, change it
to a new location for it to start operating again.
Place the charging base against the wall and leave a minimum free space
of:
2 metres to the front.
1 metre to each side.
Fig. 16
Connect the charging base to a power supply. Wind and store the remaining
cord in the lower part of the charging base to avoid accidents.
Fig. 17
Install both side brushes in their corresponding slots, located on the robot’s
bottom part. Press until it clicks to make sure they are properly xed.
Fig. 18
Press the power switch located on the bottom part of the robot. Make sure
the power switch is turned On.
Fig. 19
Place the robot on the charging base and make sure the charging terminals
on the robot match with those of the charging base. Once the robot is prop-
erly placed, it will beep once and the power button will light up If the light
blinks orange, it means the battery is not completely charged. To ensure
maximum cleaning time, wait until the light switches to steady blue. This
will indicate the battery is fully charged and that the robot is ready to clean.
Fig. 20
3. OPERATION
Start cleaning
Long press the power button on the robot to activate the robot up.
Press the power button on the robot to start cleaning.
Note: If the robot runs out of battery during cleaning, it will automatically
return to the charging base. Once the battery is fully charged, the robot can
start a new cleaning cycle.
Warning: If there is no good access to the charging base, the robot will not
be able to return to its charging position. In that case, once the robot has
stopped, take it manually to the charging base.
To Next Page
Loading...
