cecotec CONGA 1790 VITAL - Cleaning Modes

28 | CONGA 1790
ENGELSK
Pause
Press the power button on the robot to pause the cleaning process.
Press the power button on the robot to resume the cleaning process.
Fig. 21
Return to the charging base
Press the back home button on the robot in order to send the robot to the
charging base.
Turn o
Long press the power button to turn the robot o.
Fig. 22
Warning: The robot vacuum cleaner has a power switch located on its main
body. If the robot is not going to be used for long periods of time, it is sug-
gested to switch it o. If the robot is switched o, it will restore factory de-
fault settings as a safety measure. The robot will only carry out scheduled
cleaning if it has been scheduled while the switch is ON, otherwise, it will
have to be scheduled again from the App.
Cleaning modes
This robot includes dierent modes and dierent functions that can be ac-
tivated from the App.
Auto mode
Press the power button for the robot to start Auto cleaning mode.
The robot will clean the whole surface, edges, around objects such as ta-
bles, chairs etc. Once it starts running out of battery, it will return to the
charging base.
Fig. 23
Thorough Scrubbing mode
Attach the mop cloth to the water tank and ll the tank with water.
Take the dust tank out.
Install the water tank in the robot and turn it on.
Fig. 24
Use the App to select the desired scrubbing power level: High, Medium or
Low. Once the scrubbing mode is selected, the device will perform the func-
tion “All in One” to vacuum, mop, scrub and sweep at the same time thanks
to its mixed tank.
Note: If you want to sweep the oor, skip the water-lling step.