cecotec CONGA 1790 VITAL - Settings and Scheduling

CONGA 1790 | 29
ENGLESK
To ensure perfect scrubbing from the start, it is suggested to dampen the
mop cloth evenly with water before use.
Spiral mode
The robot will carry out an intense cleaning of a specic area when this
mode is activated.
The robot will start cleaning at a specic point and will move outwards per-
forming spiral movements (1 meter). Then, it will return to the starting point
in spiral movements again.
Before operating the robot under Spiral cleaning mode, place it on the spot
to be cleaned.
Press the spiral cleaning button on the App.
Fig. 25
Edge mode
When this mode is selected, the robot will clean along walls and around
furniture (table or chair legs, for example).
Press the edge cleaning button on the App.
Fig. 26
Room mode
The robot will carry out a cleaning cycle under Auto mode and then will re-
turn to the starting point.
Press the room cleaning button on the App display.
Fig. 27
To ensure an ecient cleaning of the room, close the door.
Suction power level function
Select the desired robot’s suction power during the cleaning process. There
are 3 suction power levels: Turbo, Normal and Eco. The power level function
can also be turned o if you wish to use the Wet & dry tank for scrubbing
only.
Fig. 28
Scrubbing intensity levels function
Select the desired water intensity level during the scrubbing process. There
are 3 water levels:
High, Medium or Low. The scrubbing intensity function can also be turned
o if you wish to use the Wet & dry tank for sweeping only.
Random mode
The robot will start cleaning randomly and will return to the charging base