30 | CONGA 1790
ENGELSK
smartly when it runs out of battery. The robot will not create maps under
this mode.
This mode can be activated from the App.
Manual mode
The robot can be moved manually using the direction buttons on the App.
Cleaning scheduling
This robot includes schedule settings in order for you to customise the
cleaning cycles. The robot can be scheduled through the App.
4. CLEANING AND MAINTENANCE
In order to lengthen your robot’s shelf life and to allow your robot to oper-
ate at peak performance, carry out the following procedures periodically.
Empty the robot’s dust tank.
Press the dust tank’s release button.
Fig. 29
Open the dust tank and empty it.
Fig. 30
Cleaning of the robot’s lter
Remove the lter.
Carefully shake o all dust from the lter.
Fig. 31
Cleaning of the free-fall sensors
Use a clean, dry and soft cloth to wipe o any dust from the free-fall sensor
located on the right side of the robot’s bottom part.
Warning: Do not spray cleaning products directly on the sensor.
Fig. 32
Cleaning of the main brush
Slightly press the main brush frame’s tabs in order to open the main brush
storage gap and to remove it.
Fig. 33
Remove any hair, us or dust collected in the brush and around the axes.
Fig. 34
Clear and clean the robot’s suction channel.
Fig. 35
Reinstall the main brush and its frame.
Fig. 36
To Next Page
Loading...
