cecotec CONGA 4490 - Robot Operation; Robot Button Functions; Automatic Cleaning Mode; Return to Charging Base

32 | CONGA 4490
ENGELSK
5. Operation
Once the robot’s light indicator changes from oscillating orange to steady
blue, the battery is fully charged and the robot is ready to operate.
The robot cannot operate with low battery.
Recommendations: Remove all cables and obstacles from the oor before
operating the robot in order to avoid accidents and damage.
5.1. Robot buttons
Fig. 15
Auto mode
Press the power button on the robot for it to start cleaning automatically,
rst a cleaning cycle in Edge mode and then another cycle in and organized
zigzag motion, recognizing which areas it has cleaned and which ones it has
not. The robot will automatically plan the cleaning route as it is cleaning.
If during this mode the robot is controlled manually, the robot will calcu-
late the route again and could go through previously cleaned areas. In order
to ensure ecient cleaning, do not operate it manually during auto mode
cleaning.
Thanks to its Total Surface 2.0 technology, if the battery is low during the
cleaning cycle, the robot will smartly return to the charging base automat-
ically and, once it is fully charged, it will resume the cleaning process from
the same point, oering a high-eciency cleaning.
During cleaning, the robot will stop briey to evaluate the area and calculate
the cleaning route (this stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas,
therefore it might leave the room where it is cleaning to nish o the delim-
ited area. Do not worry, the robot will clean all the accessible surface.
Back home mode
Press the back home button on the robot in order to send it to the charging
base. This mode can be activated during any other cleaning cycle and the
robot will stop cleaning and return to the charging automatically.
The robot will take the shortest route back to the charging base thanks to
its map memorizing and the smart back home function. When a cleaning
cycle has been completed or the robot’s battery is low, thanks to its Total
Surface 2.0 technology, the robot will also return to the charging base to
avoid running out of battery.
Warning: Remove the Wet & dry tank during charging.
5.2. Remote control
Fig. 16