40 | CONGA 4490
ENGELSK
Use the cleaning brush to clean the dust compartment.
Assemble the dust compartment in the Wet & dry tank.
Install the Wet & dry tank back in the robot.
If the Scrubbing mode has been used, empty the water tank and then ll it
with clean water to rinse it. Empty it again before installing it back in the
robot.
High-eciency lter
Fig. 30
Remove the high-eciency lter and shake it to remove all the dust.
Recommendations:
Replace the high-eciency lter every 3 months depending on the frequen-
cy and type of use.
Clean the lter periodically with a brush to avoid blockage.
The lter can be washed with lukewarm soapy water. Dry it thoroughly.
Side brush
Fig. 31
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to
replace the side brushes every 3 months, depending on the frequency and
type of use.
Free-fall sensors
Fig. 32
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned o and in its original pack-
age.
8. Battery replacement and charging
Do not use any other battery, power adapter or charging base than the
oneociallyprovidedby Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging
base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from
the product and store it in a dry and safe place. It is suggested to charge the
battery every month in order to avoid damage to the battery.
To Next Page
Loading...
Need help?
General
