cecotec CONGA 4490 - Scheduled Cleaning Setup

CONGA 4490 | 35
ENGLESK
Standby
The robot will automatically enter standby mode after 5 minutes of no op-
eration.
Press the time button on the App, the remote control or on the robot to start
it up again.
Warnings:
After 12 hours of no operation, the robot will turn automatically o.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired
power level. Choose between Eco (low power), Medium (medium power)
and Turbo (high power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a
time. Make sure to schedule it either from the mobile phone App or from the
remote control.
The robot is provided with a schedule function in order to provide a max-
imum-eciency cleaning. The time settings and the cleaning schedul-
ing must be carried out from the remote control. Once the robot has been
scheduled, it will automatically carry out the cleaning cycles every sched-
uled day.
Note: Make sure the robot is activated and that the light indicator is lighted
before scheduling any cleaning or setting time.
Current time
Fig. 20
Hold down the time button for 3 seconds. The rst 2 digits, indicating the
hour, will start blinking.
Use the up and down direction buttons to set the current time. Then, use
the left and right buttons to switch from hours to minutes and repeat the
before step.
Fig. 21
Press the time button to save the settings.
Scheduling cleaning tasks
Long press the schedule button for 3 seconds. The rst 2 digits, indicating
the hour, will start blinking.
Fig. 22
Use the up and down direction buttons to set the schedule time. Then, use
the left and right buttons to switch from hours to minutes and repeat the